MACHINE MAINTENANCE ACCESSORIES
LEVEL MASTER
DYNA CONTACT
LED & BUZZER INDICATION!
A ceramic taper gage allowing inspection of machine spindle tapers at a glance. • Made of ceramic • Clearly shows up Prussian blue
Device for the leveling of machine tool tables. • Simultaneous two-axis detection leveler • LED and buzzer indication when leveling is complete • Uses optical level sensor technology • 10 micron per meter precision (.01mm/m)
NEW!
WIRELESS TYPE Easy and quick leveling with a single operator.
Provided with an Aluminum Case
NEW!
ATC ALIGNMENT TOOL
AL Shank In-machine tool spindle
DYNA FORCE
Periodical measurement of the spindle retention force avoids unknown reduced rigidity, which leads to vibrations, loss of machining quality and shortened tool life. A full length taper stabilizes the value of measurements.
AL Flange In ATC arm
Only One Display for All Taper Sizes
For the maintenance of a machine tool spindle. Measure the misalignment between the ATC arm and the machine tool spindle or magazine pot center. How To Use 1. Load the AL Shank in the machine spindle and mount the AL Flange on the ATC arm. 2. Insert the AL Plug into the AL Flange. 3. Rotate the AL Plug and read the values of the dial indicator. This direction is the eccentric direction. Half of the gap of the values is the eccentric amount. 4. Adjust the position of the ATC arm so that the front end of the AL Plug will be inserted into the AL Flange fully.
Dial indicator stylus
AL Plug
50
40
30
Included: Dyna Force, Plastic Storage Case, Display and Cable
29
Powered by FlippingBook