C-CUTTER MINI OVERVIEW
Ultra High Feed Chamfer Mill Compact design with 4 inserts & small cutting diameter. High performance chamfer cutter achieves ultra high feed rate by reducing the cutting diameter to the lowest limit.
Tap Hole Chamfering
Back Chamfering Face Milling Chamfering
Chamfering
A Variety of Interfaces Available
Four Inserts, Small Diameter and New Coating Achieve a TRIPLE EFFECT EFFECT 1 — Maverick Design with Ultra High Feed by 4 Inserts Compared with 1 or 2 inserts per cutter, a 4 insert cutter multiplies the feed rate. EFFECT 2 — Increased Spindle Speed by Ultra Compact Diameter A smaller tool diameter means faster spindle speeds. EFFECT 3 — Latest Coatings [ACP200/300] Increases the Cutting Speed Wear resistant multi-layer PVD coating increases the cutting speed.
C-Cutter Mini
Competitor's Cutter
Considerably Improved!
Spindle Speed
No. of Teeth
Feed Per Tooth
Feed Rate =
Cutting Speed x Cutting Diameter
Spindle Speed
Small cutting diameter and 4 inserts!
Large cutting diameter with only 1 or 2 inserts.
Small dia.
Cutting Conditions Workpiece: S55C Chamfering Amount: C1 Feed Per Tooth fz: .1mm/t GREATER CUTTING EFFICIENCY 8 TIMES
General Products
C-CUTTER MINI (ST12-C116-45B-25)
Small Diameter
Chamfering diameter Number of inserts Cutting speed Vc (m/min) Spindle speed n (min-1)
ø29
ø13.5
Inscribed Circle ø.130
2
4
UP UP
150
300
Hex Insert Highly-efficient back chamfering from 5mm starting hole diameter. 3-corner insert saves cost.
7,040
1,646
UP
Feed Vf (mm/min)
Much Higher!
2,820
329
52
Powered by FlippingBook