BIG KAISER High Performance Tooling Solutions 2018-2019

SPEED FINISHER OVERVIEW

CUTTER DIAMETER: ø50, ø63, ø80, ø100, ø125, ø160 High Speed Cutter for Aluminum and Cast Iron Greatly improves the surface finish in ultra-high-speed machining! Achieves Rz = .55μm for die-cast aluminum ADC12 and Rz = .67μm for gray cast iron FC250.

Speedily Adjusts the Cutting Edge Height It has a simple and highly operable mechanism in which the cutting edge height is adjusted after clamping the insert by turning the lifting nut from the side, then directly pushing up the insert with the lifting screw. Since the lifting screw has a fine pitch (.25mm), accurate adjustment is possible.

Insert

Lifting Screw

Lifting Nut

Competitor Product

Combines Light Weight and High Rigidity The slim body allows increased rigidity and reduced vibration and deflection. Therefore, height difference of the machined surface is minimized. Also, as it is lighter than other cutters, it can be safely used with a small #30 taper machining center.

Direct Coolant Supply to The Cutting Edge Use in combination with the Face Mill Arbor Type FMH allows coolant to be supplied directly to the cutting edge. This prevents welding and re-cutting of chips in aluminum workpieces.

Not only has the finishing surface roughness been improved, but by correctly aligning the cutting edge height, feed per tooth can also be increased for the same surface roughness, allowing high-efficiency machining. As the insert uniformly touches the workpiece, the life can also be extended.

50

Powered by