CLEANERS
ø160 TYPE
ST20S (Steel Shank)
ST20 (Plastic Shank)
ST20-CBL160 ST20S-CBL160
Catalog Number
500min
1,000min -1
2,000min -1
-1
Startup Spindle Speed*
(.5 sec)
(.5 sec)
(.5 sec)
Min. 6,000 Max. 9,000min -1
Recommended Spindle Speed
Rotation Direction
Forward
Distance to the Workpiece Surface to be Cleaned (with wing opened to maximum)
Flange: ø2.60
3.94-5.91"
Recommended Movement Feed
118-394 ipm
*The wing may open during ATC when it is used with an ultra-high speed ATC machining center
ø260 & ø330 TYPE ST20 (Plastic Shank)
ST20-CBL260 ST20S-CBL260
ST20-CBL330 ST20S-CBL330
Catalog Number
ST20S (Steel Shank)
500min
1,000min -1
2,000min -1
-1
Startup Spindle Speed*
(.5 sec)
(.5 sec)
(.5 sec)
Min. 4,000 Max. 7,000min -1
Min. 3,000 Max. 6,000min -1
Recommended Spindle Speed
Rotation Direction
Forward
Distance to the Workpiece Surface to be Cleaned (with wing opened to maximum)
3.94-5.91"
Flange: ø2.60
Recommended Movement Feed
118-394 ipm
*The wing may open during ATC when it is used with an ultra-high speed ATC machining center
Repair Kit
Catalog Number
RK-CBL160 RK-CBL260 RK-CBL330
• Repair kit contains 4x replacement blades, 4x springs and 4x pins • Additional springs are available in sets of 10x (CBL-SP-10P)
! CAUTION
• Startup Spindle Speed — In recent high-speed machining centers, the machine spindle rotation rise has become faster. A sudden command for spindle speed may create a strong impact on the wing as it opens; therefore, be sure to rotate it at the startup speed in the table above before raising it to the designated spindle speed. • The spindle speed and the distance to the workpiece surface in the above table differ depending on the weight of the cutting chips. Be sure to confirm before use.
• The wing may open during ATC when it is used with an ultra-high speed ATC machining center. • When supplying coolant with center through, be sure to stop the spindle rotation first. • This product must be used only with a machine with a full cover. • Never modify this product in any way. • The dedicated spring must be replaced after about 20,000 use cycles. S end back the unit for replacement through your supplier.
• Although the wing is made of high-strength carbon fiber reinforced resin, it may be worn out or damaged due to the collision of cutting chips or impact when opening/closing. If wear and damage progress, the wing may snap and fly out during use. Be sure to periodically check the damage of the wing visually and replace it as needed. Send back the unit for replacement through your supplier. Individual wings are not available for sale. • The cylindrical shank outer diameter of the chip blower is ø20. Use a BIG NEW BABY CHUCK for the holder. Grasping with a holder with low inner diameter collapsibility is dangerous and must be avoided.
3
Powered by FlippingBook